Applying the Bees Wax Bar
Make sure your pants/jacket/pack is clean & dry
Run the bar back and forth over the surface (this creates a friction for the wax to loosen). Get a good even spread of the wax across the surface.
HEAT the wax into the surface using: a) A heat gun, b) A hair dryer on a HIGH setting, c) An iron set to a LOW SYNTHETIC setting
You'll know it's worked when the wax is not white & sticky to touch. Re-apply heat until it is not longer white & sticky to touch - that's when you know it's been cured into the fabric and it's waterproof again.
Leave overnight to dry and cure.